The mold should be baked according to the regulations during the production process, and the material in the barrel should be correct. In order to prevent defective products or sundries from being injected into the mold, which may block the mold, the material pipe should be thoroughly cleaned. aluminum casting moldofThe temperature of the tube and die should be compatible with the raw material being processed. If you want to produce a more satisfactory aluminum casting mold product, you should adjust the pressure and injection volume. Note that in the aluminum casting moldofIn the production process, it is impossible to discharge burrs, and some cavity products are not fully cured or even difficult to discharge burrs.

A small change in the filling rate of the aluminum casting mold is likely to cause a change in the filling rate of the mold. Therefore, before adjusting various control conditions, it should be considered. In order to reduce the overall processing cycle time, reasonable adjustments should be made. In order not to reduce the aluminum casting moldofThe weight of the product does not damage the performance of the product, and the advancing time of the screw cannot be shorter than the curing time of the gate glue. In order to make the product can be well compacted, heating the mold to extend the time of the screw.

Aluminum casting mold: In the production process, do not rush to output, but wait patiently for the state of the machine and mold to stabilize. This is the main product part for measuring and recording continuous samples. When the sample is cooled to about room temperature, its important dimensions should be measured.

In order to verify the stability of the actual operation and obtain reasonable control tolerances, at least twelve full mold samples shall be produced continuously, and the date and number shall be marked on the container and placed separately according to the mold cavity.

Description processing conditions are still changing, aluminum casting moldofThe size is indeed unstable, and some sizes have a tendency to increase or decrease. Poor temperature control or oil pressure control is to blame; dimensional variations may not be within tolerance. If the aluminum casting moldofThere is no change in size and the processing conditions are normal. You can observe whether the quality of each cavity product is qualified and whether the size can be within the allowable tolerance range; measure the number of continuous aluminum casting molds greater than or less than the average and record the number of holes to check The correct rate of mold size.